This is a trigger assembly for version 2 gearboxes. These are built using thick coper plates to reduce electrical resistance and resistance to erosion from arcing. If your not using a MOSFET I would recommend these over the SHS contacts as they seem more durable. Please note that the solder tabs are mounted differently than the stock triggers. This means that the wire runs inside the gearbox slightly and the selector plate safety switch is avoided. I assume they did this to remove the resistance caused by the selector plate contact switch.
- Nylon and copper construction
- For version 2 gearbox
This product was added to our catalog on Monday 30 April, 2012.