Your cart is empty

Nukefet Complete – V2 drop-in Mosfet


One of the most recognized names in Airsoft Mosfets, the Nukefet has earned it’s name through a long history of proven durability in any conditions. Using the International Rectifier 3034 Mosfet as it’s base the original Nukefet provides reliable electrical performance. These complete versions offer the easiest install since they have the trigger contacts, motor connectors, and Deans pre-wired. These Drop-in kits allow you to just install and go.

The NukeFet Complete is compatible with most v2 rear wired configurations. It was designed and tested to work with many G3, MP5, M4, M16 configurations but should work with other rear-wired v2 installations as well.

Please check that the following measurements are compatible with your AEG before purchasing.

When installed, the wire measurements are (approx.) as follows:
Positive motor wiring: 4.8″ (plus motor connector)
Negative motor wiring: 4.6″ (plus motor connector)
Back of gearbox to mosfet: 5.7″
Back of gearbox to battery connector: 12″

Mosfets serve two main purposes in airsoft guns. One is to take the load off the trigger contacts and use a solid state ultra powerful MOSFET to switch power to the motor instead. This means that the trigger contacts will no longer wear as they are only seeing a very small amount of current. Besides not wearing out trigger contacts a MOSFET will often increase rate of fire due to the lower resistance of the FET and new wire. Using a MOSFET is very important if you're using high powered batteries like 11.1V Lipo or high discharge 7.4V LiPos as without one your trigger contacts will very quickly be worn away by the high current arcs.

IMPORTANT: Please only use batteries rated for at least 20A discharge. The product works with 7.4v batteries, but if you are using it in a high performance AEG, please consider using an 11.1v battery instead.

You can calculate your battery’s discharge rating by taking your batteries “c” rating, and multiplying it by your mAh rating / 1000.

For example a 20c, 1500 mAh battery would be rated for 20 x 1500 / 1000 = 30A.

Max Recommended Battery Voltage: 12.8V
Wire Type: 16 ga Alpha wire / 24 ga Alpha wire

Sold Out

To be notified when this product is back in stock please click here.

  • Shipping Weight: 0.11lbs
  • 0 Units in Stock
  • Manufactured by: Nukefet

This product was added to our catalog on Saturday 15 April, 2017.

Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “Nukefet Complete – V2 drop-in Mosfet” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!